What is corona? and what is the purpose of corona belt in
substation ? why they connect these end of the buses ?

Answers were Sorted based on User's Feedback



What is corona? and what is the purpose of corona belt in substation ? why they connect these end ..

Answer / teju

carona is phenomenon of violet glow,hissing noice,ozon gas
formation in overhead transmission line.but i dont know it's
purpose.if anyone is knowing then plz send it to me at
tawadetejswita@gmail.com

Is This Answer Correct ?    3 Yes 0 No

What is corona? and what is the purpose of corona belt in substation ? why they connect these end ..

Answer / subramanyam

the ionisation of the air near the surface of the power
conductor is called as corona.due to this insulation failure
of conductor occur.due to corona their will be a real power
loss called corona loss.corona is acts as a protecting cover
for the lighting surges

Is This Answer Correct ?    3 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?

0 Answers  


What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.

0 Answers   Eskom,


how to define tell me about self

0 Answers   Bhel,


what is the difference between transformer,converter and transducer

0 Answers  


What is Magnetic Current Test of Transformer.

2 Answers  






1 no. 22 kV feeder is taken from state electricity board. 350 MVA is the S.C. MVA. now i am feeding this feeder to HT Panel having 2 outgoings which further supply to 2 Transformers. Can you please suggest me the type & rating of cables are 3 of these cables same? or they are different? please help...............

2 Answers   TCE,


in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?

0 Answers  


What is mean by single phasing used in distribution of electricity in rural area of maharashtra state?

3 Answers  


How to calculate cable size by using load.?? Any formula...

0 Answers  


what will happen if one of the phases from a 3-phase motor is disconnected?? stop/run at 2/3rd speed or run at same speed????

3 Answers  


how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???

0 Answers   Harshal Electrical,


it is clear that volts equal to the current as per ohms law. is it appliable to the AC power or only for DC. if it is appliacable to AC in transformers when voltage increases the voltage decreases ????? why??????????????

13 Answers   Bhel,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)