Answer / kathiravan.b

Electronics is a branch that deals with electronic device
characteristics,operations and its
applications.Instrumentation is branch that deals with
measurements systems,control systems and
engineering,sensors and transducers and so on.

Answer / tapu_93

Instrumentation uses electronics for its measurement,
control and protection.
Electronics is independent engineering for applying in
various engineering application.

what is the difference between single and double compression cable gland

3 Answers   Petrofac,

---

how can we caliberate interface level troll

2 Answers   Grasim, IOCL, KOC, Sankyu,

---

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

---

What is the difference between working pressure and calibration pressure of a control valve

0 Answers  

---

why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?

0 Answers  

---

what is PM/CM/RCM?

2 Answers   Emco,

---

can someone tell me about electronic speed switch &how it conect with proximittyswitch?(with dgm)

0 Answers  

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

i am working in the automation company...i want to just know how actully pid control valves are tune????...

1 Answers  

---

Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?

0 Answers   KOC,

---

If we interchange HP and LP tapping in drum level measurement and reverse LRV & URV correspondingly.What is the difference between the normal tapping(HP,LP) and reversed tapping(LP,HP)?

2 Answers  

---

if we put any thermocouple on a table in a room without any connection,what temperature should it show.

3 Answers  

---