diffuser increases pressure but in turbine pressure is decreasing when steam p

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

diffuser increases pressure but in turbine pressure is
decreasing when steam passing through casing?

Question Posted / itisthegiven

5 Answers
9966 Views
MAHINDRA, NTPC, Qatar Gas, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casin..

Answer / anju sharma

Is This Answer Correct ?

20 Yes

4 No

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casin..

Answer / ankita sharma

in turbine the area of casinng decreasing,hence velocity
will increase and pressure will decrease

Is This Answer Correct ?

22 Yes

10 No

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casin..

Answer / unni

if the flow of water is in the supersonic level inside the
pen stock pipe then the pressure will decrease when it pass
through the divergent section

Is This Answer Correct ?

5 Yes

1 No

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casin..

Answer / zainab akhtar

In turbine,fixed and rotating blades behave like nozzel,so pressure is decreased when steam passing through casing.

Is This Answer Correct ?

3 Yes

1 No

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casin..

Answer / mohan tayade

diffuser has diverging area while turbine casing has
converging area ,and we know that in converging area the
velocity will increase and pressure will decrease ,in case
of diverging area reverse of it will take place

and the draft tube which is at the delivery port of the
turbine also be one reason of theat

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

what is the equation of drag coeficient?

0 Answers

What is a liquid flooding in refrigeration system?

1 Answers RRB,

Explain bearing

0 Answers

WHY WE USE DC IN MIG WELDING

3 Answers FMI, TATA,

what is the function of a pt pump of a dg set

4 Answers

do u know about Publishing and Task in catia v5

0 Answers

what is machnical interlock? explain the uses.

1 Answers

Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?

0 Answers

1.In modal analysis ,we can give damping or not? 2.draw goodman's rankine fatigue curve? 3.write down goodman's rankine fatigue equation? 4.IN structural analysis ,out of so many stresses,why von-mises stress are chosen?

1 Answers Infotech,

What would be the effect of surface roughness on the gas flow through convergent-divergent nozzle?

1 Answers

• How do you propose to compensate for your lack of experience?

1 Answers Petro Star Mount,

Sketch the jacket cooling system?

0 Answers RRB,

For more Mechanical Engineering Interview Questions Click Here