Answer / guest

Answer: C

Answer / shakeel

Ans-C (Data, Segment, Packet, Frame)

Answer / guest

c

what does PPTP use for encryption and authentication?

0 Answers   CCIE,

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

Where shall i do CCNA cour??. can i do CCNA at home if yes then where shall i get CCNA book or simmulator.or if not then plz reff. me any good center in delhi

1 Answers  

---

When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number

1 Answers  

---

After how long eigrp protocol advertise its routing table?

0 Answers  

---

Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub

4 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

Which addresses are valid host addresses? A. 201.222.5.17 B. 201.222.5.18 C. 201.222.5.16 D. 201.222.5.19 E. 201.222.5.31

2 Answers   VGH,

---

Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in

1 Answers  

---

Hi all, suppose more than two network administrators are configure same router with different configuration through telnet at the same time.. then whose(admin's) configuration will use router for routing ?

2 Answers  

---

Which statement is true regarding Administrative distance? A.) It is a metric B.) Number of hops between two routers C.) Trustworthiness of the routing information D.) RIP Administrative distance is 100

1 Answers  

---

I received a call from client that network is down. We have 100 or 1000 of switches and routers so how could we find the client switch and its port number? and useful commands to find this ?

8 Answers   Cubicor, HCL,

---