define COMPENSATION??

Question Posted / u.nathan

4 Answers
7120 Views
Bosch, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

define COMPENSATION??..

Answer / mohammed abbas

compensation is a process of cancelling unwanted value
added to the actual value or reading of procees parameter
which will effect the quality and quantity of the product
which leads to accident or effect the cost.

Is This Answer Correct ?

7 Yes

2 No

define COMPENSATION??..

Answer / nisham

compensation is avoiding or neglecting unwanted or any
values rather than actual output.

Is This Answer Correct ?

4 Yes

2 No

define COMPENSATION??..

Answer / sunil yadav

compensation is calculated value of pv values( process variable).

Is This Answer Correct ?

0 Yes

0 No

define COMPENSATION??..

Answer / action

compensation is planning for side effects or other
unintended issues in a design

Is This Answer Correct ?

1 Yes

9 No

Post New Answer

More Instrumentation Interview Questions

what is the protection system in solar turbine compressor

0 Answers

What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC

3 Answers ADMA OPCO,

If fire would be inside the plant which fire detector is to detected the fire.

0 Answers KOC,

While giving Power Supply of 24 VDC to a Transmitter,why Shield Terminal is connected either at Transmitter or at ISB.Why not Shield Terminal connected at both ends.If the Reason is to avoid Noise interference,which type of noice that is interfering.Is the Noice from the 24 VDC supply terminals or from any external source.

1 Answers

what is difference b/w Earth and ground

2 Answers PPL,

I want to measure bidirectional steam flow? Kindly suggest me a suitable flow meter. steam is superheated at 41kg/cm2, 350°C

2 Answers

POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?

0 Answers

Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers Cisco,

Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?

0 Answers

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers

What is trim material . Why it is known as trim.

1 Answers L&T, LNG,

Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure

0 Answers

For more Instrumentation Interview Questions Click Here