Which type of switching reads just the address portion of the
frame and then immediately starts forwarding it?
A.) Cut-Through
B.) Store-and-Forward
C.) Tabling
D.) Routing
E.) Inverse ARP
F.) Fast Forward
Answer / guest
Answer: A
Cut-Through is fast, but it does not read the entire frame
and perform
any error checking before forwarding. This can result in
forwarding
errors, such as fragments.
Is This Answer Correct ? | 0 Yes | 0 No |
Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it
What is the distance limitation for 100BaseT? A. 305.955 ft B. 7283.46 inches C. 184 Meters D. 185 Kilometers
Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a
What is the network subnet?
What does the meaning of <cr >?
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port
The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
What are the 2 functions of the Data Link Mac layer? A.) Handles access to shared media B.) Manages protocol access to the physical network medium C.) Provides SAPs for higher level protocols D.) Allows multiple devices to uniquely identify one another on the data link layer
Which command we use for ping in ipv6?
In port based access-list which command u give instead of ip?