Answer / fowzan

L -Protection against overload with long inverse time-delay
trip
S -Selective protection against short-circuit with short
inverse or defi nite time-delay trip
I -Protection against instantaneous short-circuit with
adjustable trip current threshold
G- Protection against earth faults

Answer / sham

LSIG protection means overload, short circuit,instantaneous
and ground fault

Answer / pari

LSIG = Long-time + Short-time + Instantaneous + Equipment Ground-fault Protection

Answer / sagar

i its LONG SHORT INSTANTANEOUS GROUND..... so nxt time be
care ful dude

Answer / prabu a r

L- long time stands for over load protection time delay settings.
S- short time stands for short circuit time delay settings.
I- instaneous stands for instaneous short circuit time delay settings.
G- ground stands for earth fault time settings

Answer / sivaji

L-LINE TO LINE
s-short circuit
i-overload curent
g-ground fault

sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.

0 Answers  

which type of winding is used for high voltage & low current?

1 Answers   GEB,

Rotor resistance starter is used to obtain= A increased starting torque B decrease starting current C decrease starting loss D increase efficiency

1 Answers  

What are the safety devices on Cumins Diesel Generators from 500 kva to 1500 kva.

1 Answers   Maruti Suzuki,

AMF (auto mains failure) control for DG sets at home.

1 Answers  

What happens if the series current double?

0 Answers  

how to find the ballast lost from the actual wattage? for example i am going to buy decorative type 2x36watts fluorescent light fitting for this lamp how to find the ballast lost? is there any formula?

2 Answers   MEIL,

WHY IS THE NO LOAD CURRENT SMALL FOR A TRANSFORMER COMPARED TO OTHER ROTATING ELECTRICAL MACHINES??

1 Answers  

what is the procedure to carry out BDV test of a transformer ?

3 Answers   BirlaSoft,

75kw drive operated motor current fluctuation from(85-130)ampere.current setting in drive is 130amp.sometimes motor trip when current limit cross 130amps.I change the drive. still current fluctuate between 80-130amps but in this time motor not trip,current setting in drive is 130amps.where is the problem?

1 Answers  

why we use the fuse in only one wire? althrough in ac current the current flows in both directions. why the neutral wire can be taken half the magnitude of phase wire while same current returns from neutral wire?

2 Answers   Bhel,

what ll happen if neutral is not shorted with phases while doing transformer short circuit test & what ll happen if neutral is connected to ground?

1 Answers