whatare the disadvantages occur,if the form factor of
transmission will not be equal to 1.11
No Answer is Posted For this Question
Be the First to Post Answer
Differnce between Analog & Digital
why Copper loss is represented as I square R ?
raleigh method
How to select cable rating for HT/LT Panels
Advantages of low voltage drive (control panel)
Why DC exitation to AC Generator? Why not AC?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What is mathematical model of a control system?
Why does the radius of armature is less than the radius of pole shoe?
What is the better way of passing 400 amp from sending end to receiving end ? By overhead line or underground cable and why ? if underground cable then how much depth require ?
why C.T protection required for H.T.lines?
What is the function of the circuit breaker failure relay?