What are the conditions to be satisfied before connecting
two DC generators in parallel?
Answers were Sorted based on User's Feedback
Answer / kiran
polarities should be matched and relative speed between two
machines should be zero....
| Is This Answer Correct ? | 29 Yes | 3 No |
Answer / bhavya
Its not actually the phase sequence in case of DC. its polarity i guess... and also the votage rating must be the same... i go with the answer 2
| Is This Answer Correct ? | 15 Yes | 0 No |
Answer / monika hassan
The rating, phas sequence & speed of the both generators
should be same.
| Is This Answer Correct ? | 26 Yes | 16 No |
Answer / priya
the bus bar voltage of the two dc generator must be the same
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / abhishek
polarity, terminal voltage & drooping external char (Vt vs
Il).... if rising char. equalizer or cross connected fld is reqd
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / lucky
The following conditions must be satisfied for the paralleling of DC generators:
a. The polarities of the generators must be identical.
b. The terminal voltages must be the same.
c. The change of voltage with the change of load must be the same character.
d. The prime movers driving the armature of the generators must have similar and stable rotational characteristics.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / paramesh
both generators having same voltage,phase
sequence,frequncy.then only we cpnnected two generators as a
parallel
| Is This Answer Correct ? | 9 Yes | 10 No |
Answer / bharat3832
those two machines should have same output voltage and in
same frequency
| Is This Answer Correct ? | 2 Yes | 5 No |
Differentiate AC and Dc resistance
In my project i am layout cables under the Maintainance bay /Maintainance yard in the TG Building. Whether in this route i can lay the H.T.Cables??? i am taking all H.T cables from the H.T Transformer to the TG Building..
what is formula of dc current and resistance.
what is tpdt
What is meant by rating error prevention in breaker??
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
directional over current relay when acted & how it works
what is capacitor voltage transformer?? how it is different from potential transformer?
what is a DLC?[just dont reply its a Dual loop controller!] Plz do Explain the advantage of DLC over PLC?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)