Answer / guest

Answer: B E

TPC and UDP are 2 layer4 Transport protocols.

What is the checksum?

0 Answers  

---

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 Answers  

---

What is ping used for?

0 Answers  

---

Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099

1 Answers  

---

Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A) telnet B) ping C) trace D) bootp

4 Answers  

---

What is the protocol number for TCP? A.) 80 B.) 21 C.) 11 D.) 6

3 Answers  

---

Hi Anyone can share the latest ICND1 (640-822)dumps updated at 30 september 2009. specialy to Jatendra if you have any updated about the ICND1 exam.will be remain thankful.

2 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

Hi I asking one thing that my company having cisco ip phone with connected to cisco poe switch.But sometime when my agent calling to customer on that time customer voice is break only few 2 to 3 sec.I have already checked my wan link by isp and also lan connection,but this problem is not sorted out so pls help me.

5 Answers   Infotech,

---

Explain what are the ranges of private ips?

0 Answers  

---

How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64

1 Answers  

---

What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  

---