what is the difference between active and passive loop ?
Answers were Sorted based on User's Feedback
Answer / rahul sr
Passive Loop: The transducer must be provided by an
external power supply for its working. Then it generates
the signal according to the Process parameter. This may
have either 2 wires, 3 wires or 4 wires.
Active Loop: There is no need to give external power supply
for the transducer. The sensor itself generates signal
without giving power supply. This will have only 2 wires.
| Is This Answer Correct ? | 40 Yes | 22 No |
Answer / anatoli
Active input - loop is powered from card/module
Passive input - loop is powered from external source
Output loops are always active.
Number of wires is irrelevant
| Is This Answer Correct ? | 13 Yes | 2 No |
Answer / ali
Kindly check the data sheet of Stahl Transmitter Supply Unit
Field Circuit Ex i
Series 9160
and check 9160/13-10-11 as passive O/P & 9160/13-11-11 as active O/P .
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / ali
If we consider temperature sensors for example , active sensors are like LM35 -3 wires, need supply - thermocouples 2 wires -don't need supply , but both of them give mV as O/P .
on other hand pt100 can't gives O/P voltage or current with or without supply .
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / ram
Passive Loop : Two wired loop powered . It is consuming the
power and generates the signal acoording to the process
parameter values or inputs.
Active Loop : External Power supply or separate power
supply and Signals generates either two wire or four wire
concept.
| Is This Answer Correct ? | 11 Yes | 13 No |
What is the Relation Between flow and pressure. How both terms related with each other.
what is the criteria to decide conductor size of a cable ?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
What is the difference between PLC-HMI and DCS as each function of DCS based system is possible in PLC ?
what are the programming languages used in dcs
what is the process to make control schematic ?
Why Differential pressure transmitter is located below the tappings points for steam & condensible vapor flow measurement application?
What is the difference between PLC and DDC?
Why we use the remote seal transmitters
what is intools software
Explain Split Range Control In Control Valve Briefly.
Difference between guide wave radar & non guide wave radar ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)