Why is our voltage always seems to be 3.3Kv,11Kv,66Kvetc..
why not 40Kv,39Kv,65Kv???
Answers were Sorted based on User's Feedback
Answer / awaken
IT SHOULD ALWAYS IN MULTIPLE OF FORM FACTOR (1.1) ie ave/rms
value
Is This Answer Correct ? | 19 Yes | 3 No |
Answer / aree dewan
because step up and step down transformer are designed for
the selected range of voltage..
Is This Answer Correct ? | 3 Yes | 8 No |
Answer / dinesh
they r just standards like 50 hz 60 hz
no relation to form factor 1.1
remember 765kv line
Is This Answer Correct ? | 5 Yes | 11 No |
Why is the electric shock from the DC supply is more dangerous than the shock from AC supply.
What kind of preventive maintenance are there for transformer?
what is the meaning of bus bar, in electrical panels.
13 Answers HLG Habtoor Leighton Group,
in single phase circuit if i connect a heater between phase and neutral, then what will be the current path? phase to neutral or neutral to phase.
When should I use earth leakage circuit breaker for incomer and when should I use it for each feeder seperately?
What is the different between feeder & bus?
when the control mechanism is present for an ammeter(1-10A) and 1A current is apllied what will be the reading of the meter?
What is meant by the KA-rating of a circuit breaker? In this regard, discuss the stresses experienced by the circuit breakers
Capacity of circuit breakers all types
Pl. share your experience about industrial-electronics repair of machine tool.
What is meant by locking of rotor in synchronous motor? Explain me locking in detail?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.