Answer / anantharaman

No.yo cant convert ..

Answer / raeksh

Never, it's not possible

Which of the following can reply to a Novell Get Nearest Server (GNS) request? A.) Local Novell server B.) Remote Novell Printer C.) Cisco router D.) Novell client

1 Answers  

---

Which protocol switch use for filling its mac-table?

0 Answers  

---

What are the different types of the password used in securing a cisco router?

0 Answers  

---

Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

Briefly explain the conversion steps in data encapsulation.

0 Answers  

---

Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore

0 Answers  

---

what is the difference between client mode and server mode of vtp and what is the diffrence betwwen tarnsparent mode and server mode

7 Answers   Bhel, IBM,

---

What is the Between Normal Switch and Manageable Switch?

15 Answers  

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

You can access three forms of WAN services with Cisco routers. Select the three forms: A. Switched or relayed services B. Interface front end to IBM enterprise data center computers C. Using protocols that connect peer-to-peer devices like HDLC or PPP encapsulation. D. IPX/SPX E. NetBEUI

1 Answers  

---