Answer / logan

An electrical substation is a subsidiary station of an
electricity generation, transmission and distribution
system where voltage is transformed from high to low or the
reverse using transformers.

construction is explained in the books of john D Mc Donald.

Answer / g venkateshwarlu

The use of a an Electrical substation is either to step
up / stepdown the voltage of the transmission line to suit
the voltage level to be distributed either directly or
indirectly to the consumers. Normally, voltage will be
stepped down for the distribution purpose.

Transmission voltage is 400 KV in India. It will be stepped
down to 400 KV / 220 KV / 132 KV / 33 KV / 11 KV or 415V
level to suit to the requred level.

Answer / stalinborn

substation is used to change voltage level whether it is
step up or step down using transformer.The secondary of
transformer will feed to many feeders.for measurement and
protection of devices in substation there will be CT and PT.

Answer / abhidewas

substation are the place where u perform the following operation..

1) compensation of reactive power.
2) change the magnitude of voltage.

Answer / ch.narender

Conventional current is the reverse current conventional current is again connected to the main input supply through substation(please answer to its correct or not)

Answer / natesan

1. Load demand ( I think u know )
2. Reduce the voltage drop ( Government get profit )

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers   Air Force,

WHATS THE DIFFERENCE IN USING THE 125% AND THE 250% FACTOR OF SAFETY IN CALCULATING CIRCUIT BREAKERS CAPACITY IN MOTOR APPLICATION??

0 Answers  

to transmit 30kw of power at 30 km what is voltage required

2 Answers   Anglo Eastern, Merchant Navy, NPCIL,

In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?

3 Answers  

Can I use less voltage cable for neutral, since the voltage of return path is zero ideally?

3 Answers   Vijai Electricals,

In Generator How suction compression power and exhaust works ?

0 Answers   Sify,

What is meant by electrical speed?

1 Answers  

Can any body tell me the different types of LT cables & their application.

0 Answers  

What is the role and reponsibilities of Electrical Engineers in construction field?

12 Answers   ETA, Garg Electronics, L&T,

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?

0 Answers  

What are the function of different components of servo motor?

0 Answers   BARC, Parle,

Difference between low impedance and high impedance Restricted Earth Fault

0 Answers