how to calculate cable bending angle in a trench?
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
Minimum bending radius for 11KV cable -20 D for single
core,15D for multicore unarmoured,12D for multicore armoured
where D is the overall diameter of cable.25 % extra is
recommended whenever possible
Is This Answer Correct ? | 8 Yes | 1 No |
Answer / k.prakashchandra
Minimum bending radius for 11KV cable -20 D for single
core,15D for multicore unarmoured,12D for multicore armoured
where D is the overall diameter of cable.25 % extra is
recommended whenever possible
Is This Answer Correct ? | 6 Yes | 1 No |
can any one tell me the formula for calculating the power and unit consumpetion
what is pressure relief valve in D.G ?state its function?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
Why the suply frequency in INDIA is 50HZ
how i prepare for the written test in mahagenco?
2 Answers MahaDiscom, MahaGenco, Wipro,
how the capacitance is caluclated if the load is varying to keep the power factor constant(above0.95)
where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.
how the characterstics of control valve being done
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
why tertiary winding is used in transformer with diagram?
Why rotating machines are not allowed to run near critical speed region?
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.