Answer / rajeshsan

salient pole machines driven by water turbines at a speed in the range 50 ±1000 rev/min. Generally used for low speed applications. The speed depends on the type of turbine,which in turn depends on the head and the flow rate of the water available. At low speeds, the permissible rotor diameter will be several times its active length. Generally,the largest allowable diameter of rotor is used to maximise the machine's inertia which is an important part of overing the water turbine. Outputs up to 800MW have been achieved. A small high-speed unit will have a horizontal shaft, but for reasons of mechanical construction and stability larger machines have vertical shafts.

how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?

0 Answers  

---

what is the meaning of WYE and DELTA in Electric meter?

0 Answers  

---

Why generally the Rating of Transformers are in additions of 11 i.e. 11 kVA, 22 kVa, 33 kVA, etc........

8 Answers  

---

Which of the following can be operated at higher frequencies ? -SCR -MOSFET -IGBT

4 Answers  

---

Is there a chance for a motor speed to become negative..?? What is the reason for such a phenomenon.? In that case does the motor works as a generator..???

1 Answers  

---

what is the meaning of x,m,k in the relays?

0 Answers   ITC Infotech,

---

any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.

0 Answers  

---

An alternator is started without excitation then how much voltage it will produced at strating at full rpm??

4 Answers  

---

How to calculate loses in transformer of 160 KVA ?

0 Answers   IDV,

---

What about electrical Units. discrive in detail

0 Answers  

---

why impedance test in power cables?

1 Answers   CSE,

---

How to calculate the current capacity of the 3C / 1C Al/Cu power cable???

2 Answers  

---