Answer / myo zaw

I think Main Incomer is like our house main switch like 60 Amp
and feeder is like our lighting switch or sub main breaker.
Because all the VCB structure of incomer and feeder is same but different is its current carrying capacity .Most of the incomer is for eg 33 kV , 1250 Amp and the feeder is 33 kV 630 Amp.

Answer / vijaykumar

there won't be any differenece b/w VCB's used in the
incomer or outgoing feeder provided the current ratings of
both are same.The protection and control wiring differs b/w
them as incomer needs only U/V,O/V,O/C,E/F protections but
the outgoing contains differnet protections depending upon
the load requirements.

I have a 3 phase 600 volt prim. feed and a 120/208 sec. Isolateing tranformer .We are using this system for safety against shock . What is the proper grounding ?? Does the common on sec. get earth ground ???

1 Answers  

---

to transmit 30kw of power at 30 km what is voltage required

2 Answers   Anglo Eastern, Merchant Navy, NPCIL,

---

how can i get the entrance exam papers

0 Answers  

---

we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.

0 Answers  

---

What will hapen if we run generator below 47.6hz frequency?

9 Answers   TATA,

---

Why do we use copper cable for HT Supply and why not Aluminium?

0 Answers  

---

Draw SLD for a panel has 500A Bus Bar rating, with 4 outgoing, each is 80 A (load current), showing the transformer and capacitor bank rating.

0 Answers   FEWA,

---

What is the difference between Isolator & Load Break Switch?

7 Answers   Infotech,

---

which motor will u use in refinaries?

1 Answers   IOCL,

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

how we are desining 63.5 ohm resistor for NGR of alternator?

1 Answers  

---

Even when a particular generator in a generating station is under maintenance we are still able to maintain the same power output. How is this possible? Does the tie line between 2 generating stations have a role to play in it?

1 Answers   NTPC,

---