Answer / lova subrahmanyam

woodward 505 best governer to control only inlet steam to
the to turbine

woodward 505E for control inlet steam and extractions of
steam turbine

Answer / ramesh

woodward 505 is the governor for the steam turbine it
controls the inlet steam , speed & extraction steam
generally it having so many options it needs the to rpm
sensors the advance system of 505 is 505E

Answer / ailesh

WOODWARD 505 IS BASICALLY SPEED CONTROLLER FOR TURBINE.
SENSE INPUT FROM SPEED SENSOR, COMPARES IT WITH SETPOINT
AND GENERATES THE OUTPUT WHICH OPERATES THE STEAM CONTROL
VALVE.

Answer / muataz

how to use 505E for standard steam turbine

Q- In the process of checking AC through Phase Tester our body is the part of circuit but we don't recevie Shock, Why ?

2 Answers  

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure

0 Answers  

---

how can calibrate vacume trasmitter by HART COMMUNICATOR ?

3 Answers   Bajaj, IMECO,

---

A pressure Tx accuracy is 0.2%. Signal o/p is 4-20ma.span is 16 Ma.how many deviate the o/p then calibration needed

1 Answers  

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

wht is loops ? how many loops are there?

2 Answers  

---

any questions on motor and energy conversions machines?

0 Answers   ABB,

---

how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr

0 Answers  

---

if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?

1 Answers   MPL,

---

what would be the minimum flow rate that we can measure on rotameter..?

0 Answers   TATA,

---

I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.

0 Answers  

---