Answer / sunil

series reactor is used to limit the fault current. b'cos
reactor contains inductance and it opposes the rate of
change of current

Answer / ajit

to minimise the starting shotckt current

Answer / niaz ahmed bijapure

to limit short circuit current
to reduce 1 2 3 harmonic
to reduce inrush current
to increase inductance , reflectance of circuit

Answer / biswajit sahoo

to reduce harmonics

Answer / sailaja

they are used to reduce fault currents

Answer / sibasish

to limit short circuit current
to reduce 1 2 3 harmonic
to reduce inrush current
to increase inductance , reflectance of circuit

Answer / mangesh karande

To limit short circuit currents and thus to reduce fault
MVA. Also to keep to sources permanantly parallel.

Answer / som

It is installd 2 cmpensate
inductive VAR and stable the
voltage profile in receiving
end side.

Answer / shravan kasaudhan

For reducing the scc(short circuit capacity).
Then faulty current will be reduced and size of switch gear will be reduced I.e.cast of switch gear equipment is no more

I want d.g.set our company

0 Answers  

would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?

0 Answers  

in thermal power plant the steam produced is made to cool after falling on the turbine blades. my question is why this is done while the same is needed to heat up again. "jab pani ko wapis garam hi karna hai to thanda kyu karte hai"

11 Answers   Bhel,

working principle of induction motor is similar to transformer. but what makes it to rotate? then why the transformer doesnt?

4 Answers  

how can we avoid magnetostriction in transformer?describe the suitable methods.

3 Answers   Bhel,

Which device of PlC does share load between DG sets when DG are running in perallel?

0 Answers  

Why generating power limited to 11kv?

4 Answers   PSU,

What is mean by nominal voltage,Explain?.How much nominal voltage?.

1 Answers  

A jet of fluid strikes a plate What was the force required to counter it?

0 Answers  

what are the standard values for resistances(Megger testing) between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?

1 Answers  

sir plz send some previous year questions of jspl.

0 Answers  

why battery is connected in series?

10 Answers   HP,