Answer / pradeep kumar dhar

The resistance value varies according to the nature of the
soil.It is very high for rocky soils.A value of 1 ohm or
less is considered to be very good.Several pits are
interconnected to reduce the value of earth resistance.

Answer / shri..

It should be bellow one ohm

Answer / vikram

The resistance value depanded to the nature of the
soil.The resistance value is very high for Hill area. when
resistance value of lessthan 1 ohm this value is very good.

Answer / parmod kumar

The resistance value of Earth Pit should below 1 Ohm &
Earth pit are connected to reduce the earth resistance
value.

Answer / ajoy kumar

In some cases like rocky soil, the resistance value of individual earthpit become more than 5 ohms. For these cases, we can consider the combined earthing and it should be atleast less than 1 ohm.

Answer / &

the earth resistance
more than 1. and any
switch yard
maintain...earth
resistance below 3
meter, with the mat
giiii

how does an energy meter works?

4 Answers  

I know current,volt,powerfactor of an electrical line. In this line how I will calculate Active power and Reactive power

2 Answers  

1.Difference between vcb and Acb and partes. 2.Difference between STS and ATS.

2 Answers  

What are the tests to be conducted in the electrical installations

1 Answers  

For a 50MVA (138/69/13.8 KV) transformer, what would be the maximum demand in order not to exceed 80% of its operating capacity.

2 Answers  

why choke is provided in the centre of the tube light?

3 Answers  

what should be correct gas pressures to be a 1.5 ac unite

0 Answers   DDK,

Our Alternator nameplate specifies a power factor of 0.8. When the Alternator is on light load, the bus bar voltage rises to 11240 volts, whereas the standard value is 10500 volts. Is it ok to increase the power factor to 0.85 or 0.9. I am afraid because the power factor on the name plate is only 0.8 ?

3 Answers   Escube,

I have an 15A fuse MCB that controls a night storage heater. It needs replacing and is now obsolete. Is a 16A C curve MCB the correct replacement?

2 Answers  

what is Micrologic 6.0A advantages over Micrologic 2.0A

1 Answers  

Why Diffrential and Ref relays are used together although Diffrential relay can protect Pri and Sec of Transformer

1 Answers   Qatar Gas,

Can anyone explain the power flow in flouresent lamps (tube lights) .What are the functions of Starter & choke used there?

1 Answers